[sisyphus] zebra

[sisyphus] zebra

[Andrey S. Pankov]

casper.newtel# conf t
casper.newtel(config)# int eth0
casper.newtel(config-if)#
  Negate     Interface Internet Protocol config commands
^^^^^^^^^^^^^^^^^^^^^^
должно быть "no   Negate...", при этом в парсере при нажатии ?
выплывает следующее слово фразы "Negate "

  bandwidth  Set bandwidth informational parameter
  end        End current mode and down to previous mode
  exit       Exit current mode and down to previous mode
  ip         Interface Internet Protocol config commands
  ipv6       Interface Internet Protocol config commands
  list       Print command list
  multicast  Set multicast flag to interface
  no         Negate a command or set its defaults
  ospf       OSPF interface commands
  quit       Exit current mode and down to previous mode
  shutdown   Shutdown the selected interface
  write      Write running configuration to memory, network, or terminal
casper.newtel(config-if)#Negate
  a  Set the IP address of an interface
casper.newtel(config-if)# Negate a
  command  IP address (e.g. 10.0.0.1/8)
casper.newtel(config-if)# Negate a command
  or  Secondary IP address
casper.newtel(config-if)# Negate a command or
  set
casper.newtel(config-if)# Negate a command or set

zebra-alt2 & alt4 tested.

--
Best regards,
Andrey aka Casper.