* [Comm] ALPD 4.0: USB-drive - проблемы при автомонтировании
@ 2007-10-25 10:46 Безруков Александр
0 siblings, 0 replies; only message in thread
From: Безруков Александр @ 2007-10-25 10:46 UTC (permalink / raw)
To: community
Привет всем!
Объясните пожалуйста почему при подключении USB-drive автомонтирование иногда
происходит с первого раза, а иногда со 2, 3 или вообще 5?
Такая же картина наблюдалась и в ALC 3.0.
Прилагаю кусок /var/log/messages в случае автомонтирования со 2 раза
--------------------------------------- messages ---------------------------
================ 1 раз =========================
host kernel: usb 3-4: new high speed USB device using ehci_hcd and address 2
host kernel: usb 3-4: configuration #1 chosen from 1 choice
host kernel: usbcore: registered new driver libusual
host kernel: Initializing USB Mass Storage driver...
host kernel: scsi4 : SCSI emulation for USB Mass Storage devices
host kernel: usbcore: registered new driver usb-storage
host kernel: USB Mass Storage support registered.
host kernel: Vendor: StoreJet Model: StoreJet Rev: tor
host kernel: Type: Direct-Access ANSI SCSI revision:
02
host kernel: SCSI device sdc: 39069824 512-byte hdwr sectors (20004 MB)
host kernel: sdc: Write Protect is off
host kernel: sdc: assuming drive cache: write through
host kernel: SCSI device sdc: 39069824 512-byte hdwr sectors (20004 MB)
host kernel: sdc: Write Protect is off
host kernel: sdc: assuming drive cache: write through
host udevd-event[20942]: wait_for_sysfs: waiting
for '/sys/devices/pci0000:00/0000:00:13.2/usb3/3-4/3-4:1.0/host4/target4:0:0/4:0:0:0/ioerr_cnt'
failed
host kernel: sdc: sdc1
host kernel: sd 4:0:0:0: Attached scsi removable disk sdc
host kernel: sd 4:0:0:0: Attached scsi generic sg2 type 0
host kernel: usb 3-4: USB disconnect, address 2
================ 2 раз через 20 секунд=================
host kernel: usb 3-4: new high speed USB device using ehci_hcd and address 3
host kernel: usb 3-4: configuration #1 chosen from 1 choice
host kernel: scsi5 : SCSI emulation for USB Mass Storage devices
host kernel: Vendor: StoreJet Model: StoreJet Rev: tor
host kernel: Type: Direct-Access ANSI SCSI revision:
02
host kernel: SCSI device sdc: 39069824 512-byte hdwr sectors (20004 MB)
host kernel: sdc: Write Protect is off
host kernel: sdc: assuming drive cache: write through
host kernel: SCSI device sdc: 39069824 512-byte hdwr sectors (20004 MB)
host kernel: sdc: Write Protect is off
host kernel: sdc: assuming drive cache: write through
host kernel: sdc: sdc1
host kernel: sd 5:0:0:0: Attached scsi removable disk sdc
host kernel: sd 5:0:0:0: Attached scsi generic sg2 type 0
host kernel: VMBlock warning: DentryOpRevalidate: invalid args from kernel
---------------------------------------
С уважением, Безруков А.
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2007-10-25 10:46 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2007-10-25 10:46 [Comm] ALPD 4.0: USB-drive - проблемы при автомонтировании Безруков Александр
ALT Linux Community general discussions
This inbox may be cloned and mirrored by anyone:
git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git
# If you have public-inbox 1.1+ installed, you may
# initialize and index your mirror using the following commands:
public-inbox-init -V2 community community/ http://lore.altlinux.org/community \
mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com
public-inbox-index community
Example config snippet for mirrors.
Newsgroup available over NNTP:
nntp://lore.altlinux.org/org.altlinux.lists.community
AGPL code for this site: git clone https://public-inbox.org/public-inbox.git