Re: [sisyphus] Re: сизиф от 27.11

["Антон Горлов" <stalker@altlinux.ru>]

[-- Attachment #1: Type: text/plain, Size: 576 bytes --]

Konstantin A. Lepikhov пишет:

>>Немного логов в аттаче....
> интересно посмотреть на логи в момент виса. Правда, для этого нужна еще
> одна машина и netconsole.
Ага..только где взять такое богатство. :-)
В общем по совету vsu отрубил фреймбуффер.. Виснуть перестало,xmoto 
запустился... nexus по прежнему запускается..но тормозит даже звук в 
нём. :-(


>>Хотя в биосе стоит 4x
> А это пофиг. Для этого есть параметр AGPMode (см. radeon(4x)).
Ага..а fastwrite теперь тоже из конфига рулится?

В общем в аттаче diff dmesg при включенном framebuffer и без.

-- 
   np: silence

[-- Attachment #2: diff --]
[-- Type: text/plain, Size: 5315 bytes --]

--- dmesg	2005-12-11 13:58:35 +0300
+++ dmesg1	2005-12-11 14:13:00 +0300
@@ -27,7 +27,7 @@
 PID hash table entries: 2048 (order: 11, 32768 bytes)
 Detected 902.360 MHz processor.
 Using pmtmr for high-res timesource
-Console: colour dummy device 80x25
+Console: colour VGA+ 80x25
 Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
 Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
 Memory: 515216k/524224k available (1807k kernel code, 8456k reserved, 767k data, 204k init, 0k highmem, 0k BadRAM)
@@ -76,21 +76,13 @@
 PCI: Using ACPI for IRQ routing
 PCI: If a device doesn't work, try "pci=routeirq".  If it helps, post a report
 audit: initializing netlink socket (disabled)
-audit(1134308849.466:0): initialized
+audit(1134310229.313:0): initialized
 Total HugeTLB memory allocated, 0
 VFS: Disk quotas dquot_6.5.1
 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
 Initializing Cryptographic API
 Applying VIA southbridge workaround.
 PCI: Disabling Via external APIC routing
-vesafb: framebuffer at 0xd0000000, mapped to 0xd0880000, using 6144k, total 16384k
-vesafb: mode is 1024x768x16, linelength=2048, pages=9
-vesafb: protected mode interface info at c000:577a
-vesafb: scrolling: redraw
-vesafb: Truecolor: size=0:5:6:5, shift=0:11:5:0
-bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found (1024x768, 80505 bytes, v2).
-Console: switching to colour frame buffer device 105x34
-fb0: VESA VGA frame buffer device
 isapnp: Scanning for PnP cards...
 isapnp: No Plug & Play device found
 PNP: PS/2 Controller [PNP0303:PS2K,PNP0f03:PS2M] at 0x60,0x64 irq 1,12
@@ -123,7 +115,6 @@
 VFS: Mounted root (romfs filesystem) readonly.
 Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
-input: AT Translated Set 2 keyboard on isa0060/serio0
 VP_IDE: IDE controller at PCI slot 0000:00:07.1
 PCI: Via IRQ fixup for 0000:00:07.1, from 255 to 0
 VP_IDE: chipset revision 6
@@ -132,6 +123,7 @@
     ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA
     ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA
 Probing IDE interface ide0...
+input: AT Translated Set 2 keyboard on isa0060/serio0
 hda: ST3160023A, ATA DISK drive
 hdb: MAXTOR 6L040J2, ATA DISK drive
 ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
@@ -234,7 +226,7 @@
 ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[10]  MMIO=[dffff800-dfffffff]  Max Packet=[2048]
 8139too Fast Ethernet driver 0.9.27
 ACPI: PCI Interrupt 0000:00:0c.0[A] -> Link [LNKA] -> GSI 11 (level, low) -> IRQ 11
-eth0: RealTek RTL8139 at 0xd1446600, 00:50:22:e1:0a:12, IRQ 11
+eth0: RealTek RTL8139 at 0xd0cac600, 00:50:22:e1:0a:12, IRQ 11
 eth0:  Identified 8139 chip type 'RTL-8100B/8139D'
 gameport: EMU10K1 is pci0000:00:0f.1/gameport0, io 0xdc00, speed 1217kHz
 ieee1394: Host added: ID:BUS[0-00:1023]  GUID[0011026650555e44]
@@ -246,39 +238,13 @@
 NET: Registered protocol family 17
 process `syslogd' is using obsolete setsockopt SO_BSDCOMPAT
 [drm] Initialized drm 1.0.1 20051102
-PCI: Unable to reserve mem region #1:8000000@d0000000 for device 0000:01:00.0
+ACPI: PCI Interrupt 0000:01:00.0[A] -> Link [LNKA] -> GSI 11 (level, low) -> IRQ 11
 [drm] Initialized radeon 1.19.0 20050911 on minor 0: ATI Technologies Inc RV280 [Radeon 9200]
-[drm] Used old pci detect: framebuffer loaded
 agpgart: Found an AGP 2.0 compliant device at 0000:00:00.0.
 agpgart: Putting AGP V2 device at 0000:00:00.0 into 4x mode
 agpgart: Putting AGP V2 device at 0000:01:00.0 into 4x mode
 [drm] Loading R200 Microcode
-bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found (1024x768, 80505 bytes, v2).
-bootsplash: status on console 1 changed to on
-bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found (1024x768, 80505 bytes, v2).
-bootsplash: status on console 2 changed to on
-bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found (1024x768, 80505 bytes, v2).
-bootsplash: status on console 3 changed to on
-bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found (1024x768, 80505 bytes, v2).
-bootsplash: status on console 4 changed to on
-bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found (1024x768, 80505 bytes, v2).
-bootsplash: status on console 5 changed to on
-bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found (1024x768, 80505 bytes, v2).
-bootsplash: status on console 11 changed to on
 warning: process `update' used the obsolete bdflush system call
 Fix your initscripts?
 warning: process `update' used the obsolete bdflush system call
 Fix your initscripts?
-end_request: I/O error, dev fd0, sector 0
-end_request: I/O error, dev fd0, sector 0
-end_request: I/O error, dev fd0, sector 0
-end_request: I/O error, dev fd0, sector 0
-subfs: /sbin/submountd unsuccessful attempt to mount media (256)
-cdrom: open failed.
-cdrom: open failed.
-subfs: /sbin/submountd unsuccessful attempt to mount media (256)
-cdrom: open failed.
-cdrom: open failed.
-subfs: /sbin/submountd unsuccessful attempt to mount media (256)
-NTFS-fs error (device hda7): ntfs_ucstonls(): Unicode name contains characters that cannot be converted to character set koi8-r.
-NTFS-fs error (device hda7): ntfs_ucstonls(): Unicode name contains characters that cannot be converted to character set koi8-r.