[Hardware] проблемы с 3ware 9590SE-8ML и 4 single disk

[<_kaa_@mail.ru>]

Приветствую.

Поставил на своей домашней машинке данный контроллер
http://3ware.com/products/serial_ata2-9590.asp

Ибо харды уже были и места, на чем создавать именно raid подходящего объема, 
небыло, харды были поочередно подключены в контроллер, т.е. ставился пустой 
хард, подключался как single disk, затем на него вливалось все, что было на 
другом харде, вклоюченном через материнку ASUS A8N-E и так все харды 
переехали под контроллер.
Все бы ничего и хорошо, но... если включены все 4 харда, то система не 
бутится, а просто висит и чего-то ждет, висит в том месте, где обычно 
появляется сообщение аля "NO SYSTEM DISK" и т.п.
если включен только 1 хард, на котором система - все загружается как положено 
и после чего на ходу просто подцепляются руками остальные, после чего система 
полностью работоспособна.

Firmware контроллера обновил до последней.

Кто-нибудь сталкивался с похожей ситуацией и решил ли ее, если да?

Собственно по этому поводу пообщался с web тех.поддержкой 3ware:
(английский не мой конек, но смысл, думаю, ясен всем и должен был быть ясен и 
им.)
----------------------------------------------------------------------------------------------------
Request:-  1st March 2007 at 6:52
        Hello,
i have a problem booting OS, then i have active 4 single drive mode hard disks 
in controller(system pused/freezed before read mbr), when where are is only 
one - boot going ok, after this i plug-in sata cables in hard-disks and thay 
fully available in the OS after rescan.
I didn't find any options  in BIOS of controller, to  force select boot 
harddisk.
Can you help me?
I do not want create raid0/1/5/10/50 etc.. i need all my drives as single 
disks. It is possible to boot from one of four single harddisk?
Controller Summary
ID 	Model 	Serial # 	Firmware 	Driver 	Status
2 	9590SE-8ML 	L323034A6390311 	FE9X 3.04.01.011 	2.26.02.008 	OK



Response:- 1st March 2007 at 12:16
        Hi Alesander, 

In the system Bios you can choose the boot order and you can setup from which 
hard drive you should boot. 

Sincerely,
AMCC Customer Support, 
Tech 6. 



Request:-  1st March 2007 at 13:20
        this is joke? o may be my English so bad... sorry...
in BIOS of motherboard boot order selected like this:
1. 3Ware RAID Controller
2. CDROM
and nothing else.
after motherboard BIOS initialized successfully we see 3Ware full information 
table with hard disks attached to 3Ware controller (look up in my previous 
message in Combination Description )
_all my hard disks attached to 3Ware RAID Controller_
when attached disks 0(with 2 system - win xp and Linux, boot manager is LILO) 
1 2 3 - boot process dasn't start, when i detach disks 1 2 3 and only disk 0 
still attached to 3Ware RAID Controller - boot process begin normally as i 
need.
My question is: can i boot OS normally with attached to 3Ware RAID Controller 
hard disks 0 1 2 3 which each in SINGLE MODE, not any RAID mode.

I think problem is more complex, than just boot order of disks, if order is 
not right, then i must see NO SYSTEM DISK, but i can't see anything, it's 
like system freeze or waiting something without any prompt.
Looks like the SINGLE DISK may be only one... but i need 4 for now and all 8 
later... is this possible?

Response:- 2nd March 2007 at 10:55
        Hi Alexander,

Yes it is possible to boot of the single hard disk . notmally the MBS is 
written to the fist available disk that would be the drive on port0 

Sincerely,
AMCC Customer Support,
Tech 6.


Request:-  2nd March 2007 at 13:22
        :) but it dasn't boot... :) did your read all of i'm writing?
single disk with two OS and MBR on port 0 boot only when it one and only one, 
when it together with other three disks ,which every in SINGLE DISK mode, - 
it do not want boot.
May be you can repeat this configuration in lab?
Unit Information (Controller ID 2) 
Unit Name Type Capacity 
0(P0) SYSTEM SINGLE DISK 698.48 GB - two OS, MBR,boot loader.
1(P1) STORAGE1 SINGLE DISK 698.48 GB - storage
2(P2) STORAGE2 SINGLE DISK 698.48 GB - storage
3(P3) STORAGE3 SINGLE DISK 279.39 GB - storage
0(P0) + 1(P1) + 2(P2) + 3(P3) - dasn't boot
0(P0) - boot normal

Request:-  6th March 2007 at 2:42
        hello again,
what about my situation?
can your repeat it or your think this is my problem and do not 3Ware problem?

Response:- 6th March 2007 at 14:26
        Hello Alexander,
Make sure that the boot disk is attached port 0.
Then you should be able to boot.
Thank you,
Joseph


Request:-  7th March 2007 at 2:55
        i am sure, very much sure, sure as a steel in this information from 
controller(again and again and again, i'm seem, i'm not a parrot ):
Unit Information (Controller ID 2) 
Unit Name Type Capacity 
0(P0) SYSTEM SINGLE DISK 698.48 GB - two OS, MBR,boot loader.
^^^^ - this is P0(also marked with marked sata cable), first drive with system
1(P1) STORAGE1 SINGLE DISK 698.48 GB - storage
2(P2) STORAGE2 SINGLE DISK 698.48 GB - storage
3(P3) STORAGE3 SINGLE DISK 279.39 GB - storage
this is true configuration without any missconfiguration, and information 
_from_ controller, 

_if_ i remove _only_ _1(P1),2(P2)3(P3)_ - then system boot normal, lilo 
wsrking and i can boot and linux and windows, after this i can hot-attach 
other 1,2,3 single disk to 3ware without reboot and i can work with all of my 
4 single disk drive.

again.
0(P0) + 1(P1) + 2(P2) + 3(P3) - dasn't boot
0(P0) - boot normal

please, be more mindfully, try to understand, consult with engineer,repeat 
configuration in the laboratory with same controller 4 harddisks on single 
disk mode and lilo as boot manager.

i understand, 9590  is a raid controller, but if function "single disk" 
asserted - must be realized in full range and where are must be no difference 
1 single disk or 8 single disk in controller.

Response:- 7th March 2007 at 16:15
        You might want to change the boot priority boot order.

Go to Boot-menu->boot-device-priority->hard-disks

You probably will see 3ware card and bootable add-in card. Changing the order 
there might fix your boot problem. Thanks
-----------------------------------------------------------------------------------------------------

-- 
__________________________________________________
Alexander Kubatkin