From: Игорь <mailvisor@mail.ru>
To: "ALT Linux Community" <community@lists.altlinux.org>
Subject: [Comm] Sat Internet
Date: Wed, 08 Feb 2006 17:20:53 +0300
Message-ID: <op.s4nrg3ntix01cm@gate> (raw)
Сори.
Доброго времени суток, сообщество.
Подскажите, где можно прочитать о настройке спутникового интернета.
У меня:
локалка eth1
земля по ADSL (через Ethernet eth0).
SkyStar2 dvb0_0.
Что удже сделано:
1. DVB настроена и работает (смотрю TV)
2. Net interface DVB поднят:
(выдержка из ifconfig):
dvb0_0 Link encap:Ethernet HWaddr 00:D0:D7:01:1B:62
inet addr:192.168.168.168 Bcast:192.168.168.255
Mask:255.255.255.0
UP BROADCAST RUNNING NOARP MULTICAST MTU:4096 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Base address:0x103c
3. VPN поднят, но что-то гложат сомнения, что правильно
(хотя VPN сервер провайдера IP-выдал правильно, сверено с виндами)
(выдержка из ifconfig):
ppp0 Link encap:Point-to-Point Protocol
inet addr:10.255.252.88 P-t-P:1.1.1.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1460 Metric:1
RX packets:6 errors:0 dropped:0 overruns:0 frame:0
TX packets:228610 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:65 (65.0 b) TX bytes:79944724 (76.2 Mb)
Смущает: P-t-P:1.1.1.1 потому как на 1.1.1.1 pppd настраивает
default route
Вот ifconfig полностью :
dvb0_0 Link encap:Ethernet HWaddr 00:D0:D7:01:1B:62
inet addr:192.168.168.168 Bcast:192.168.168.255
Mask:255.255.255.0
UP BROADCAST RUNNING NOARP MULTICAST MTU:4096 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Base address:0x103c
eth0 Link encap:Ethernet HWaddr 00:02:44:4B:D0:D6
//******** ADSL
inet addr:172.16.65.122 Bcast:172.16.65.123
Mask:255.255.255.252
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:17308 errors:0 dropped:0 overruns:0 frame:0
TX packets:7929 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:7091076 (6.7 Mb) TX bytes:1082378 (1.0 Mb)
Interrupt:19 Base address:0xe000
eth1 Link encap:Ethernet HWaddr 00:0A:E6:96:FF:9C //********
локалка
inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:7385 errors:0 dropped:0 overruns:0 frame:0
TX packets:9242 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1022603 (998.6 Kb) TX bytes:6747238 (6.4 Mb)
Interrupt:20
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:342 errors:0 dropped:0 overruns:0 frame:0
TX packets:342 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:582310 (568.6 Kb) TX bytes:582310 (568.6 Kb)
ppp0 Link encap:Point-to-Point Protocol /// *************
тунель
inet addr:10.255.252.88 P-t-P:1.1.1.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1460 Metric:1
RX packets:6 errors:0 dropped:0 overruns:0 frame:0
TX packets:228610 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:65 (65.0 b) TX bytes:79944724 (76.2 Mb)
Так выглядит route -n после старта pppd
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
1.1.1.1 * 255.255.255.255 UH 0 0 0
ppp0
172.16.65.120 * 255.255.255.252 U 0 0 0
eth0
192.168.0.0 * 255.255.255.0 U 0 0 0
eth1
192.168.168.0 * 255.255.255.0 U 0 0 0
dvb0_0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 1.1.1.1 0.0.0.0 UG 0 0 0
ppp0
Вижу , что неправильно настроена маршрутизация, но где не пойму.
Еще стоит iptables, в нем тоже настройки на тарелку не делались (только
чистый ADSL - работает),
но с ним после настройки маршрутизации
Читал:
http://www.opennet.ru/base/net/skystar2_setup.txt.html
/usr/share/doc/pptp-client-1.5.0/readme.rus
ХЭлп ми плиз, кто может!!!
_____________________________________________________
Мажурин Игорь.
mailvisor@mail.ru
_____________________________________________________
next reply other threads:[~2006-02-08 14:20 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2006-02-08 14:20 Игорь [this message]
2006-02-08 14:52 ` Genix
2006-02-08 15:44 ` [OBORONA-SPAM] " ABATAPA
2006-02-08 15:38 ` Игорь
2006-02-08 16:53 ` ABATAPA
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=op.s4nrg3ntix01cm@gate \
--to=mailvisor@mail.ru \
--cc=community@lists.altlinux.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
ALT Linux Community general discussions
This inbox may be cloned and mirrored by anyone:
git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git
# If you have public-inbox 1.1+ installed, you may
# initialize and index your mirror using the following commands:
public-inbox-init -V2 community community/ http://lore.altlinux.org/community \
mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com
public-inbox-index community
Example config snippet for mirrors.
Newsgroup available over NNTP:
nntp://lore.altlinux.org/org.altlinux.lists.community
AGPL code for this site: git clone https://public-inbox.org/public-inbox.git