From: Eugene Prokopiev <prokopiev@stc.donpac.ru>
To: ALT Linux Community general discussions <community@lists.altlinux.org>
Subject: Re: [Comm] Чем мониторить заряд батареи ноутбука
Date: Tue, 09 Oct 2007 22:23:01 +0400
Message-ID: <470BC705.8000508@stc.donpac.ru> (raw)
In-Reply-To: <470BC38C.2010903@stc.donpac.ru>
Eugene Prokopiev пишет:
> Igor Zubkov пишет:
>> 2007/10/8, Eugene Prokopiev:
>>> А чем лучше мониторить заряд ноутбука в трее KDE и OpenBox? И что
>>> треевской программе для этого потребуется (демон какой запущенный)?
>> apt-get install wmacpi
>>
>> У меня работало на ура. Сейчас ноута просто нет. :)
>
> при запущенном acpid оно утверждает: No batteries or ACPI not supported
Примерно то же самое утверждает клиент acpi. Но:
# dmesg | grep ACPI
BIOS-e820: 000000003f680000 - 000000003f700000 (ACPI NVS)
ACPI: RSDP (v002 ACRSYS ) @ 0x000f6cc0
ACPI: XSDT (v001 ACRSYS ACRPRDCT 0x06040000 LTP 0x00000000) @ 0x3f686e3c
ACPI: MADT (v001 Acer Acadia 0x06040000 LOHR 0x0000005a) @ 0x3f68dc04
ACPI: HPET (v001 Acer Acadia 0x06040000 LOHR 0x0000005a) @ 0x3f68dc6c
ACPI: MCFG (v001 Acer Acadia 0x06040000 LOHR 0x0000005a) @ 0x3f68dca4
ACPI: SLIC (v001 ACRSYS ACRPRDCT 0x06040000 LOHR 0x00000000) @ 0x3f68dce0
ACPI: DBGP (v001 Acer Acadia 0x06040000 LOHR 0x00000000) @ 0x3f68de56
ACPI: FADT (v003 Acer Acadia 0x06040000 LOHR 0x00000001) @ 0x3f68de8a
ACPI: MADT (v001 PTLTD APIC 0x06040000 LTP 0x00000000) @
0x3f68df7e
ACPI: BOOT (v001 PTLTD $SBFTBL$ 0x06040000 LTP 0x00000001) @ 0x3f68dfd8
ACPI: SSDT (v001 SataRe SataAhci 0x00001000 INTL 0x20050228) @ 0x3f687aad
ACPI: SSDT (v001 PmRef Cpu0Cst 0x00003001 INTL 0x20050228) @ 0x3f6875eb
ACPI: SSDT (v001 PmRef Cpu0Tst 0x00003000 INTL 0x20050228) @ 0x3f68738c
ACPI: SSDT (v001 PmRef CpuPm 0x00003000 INTL 0x20050228) @ 0x3f686ec0
ACPI: DSDT (v001 Acer CALISTGA 0x06040000 INTL 0x20060608) @ 0x00000000
ACPI: PM-Timer IO Port: 0x1008
ACPI: Local APIC address 0xfee00000
ACPI: 2 duplicate APIC table ignored.
ACPI: LAPIC (acpi_id[0x00] lapic_id[0x00] enabled)
ACPI: LAPIC (acpi_id[0x01] lapic_id[0x01] disabled)
ACPI: LAPIC_NMI (acpi_id[0x00] high edge lint[0x1])
ACPI: LAPIC_NMI (acpi_id[0x01] high edge lint[0x1])
ACPI: IOAPIC (id[0x01] address[0xfec00000] gsi_base[0])
ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 dfl dfl)
ACPI: INT_SRC_OVR (bus 0 bus_irq 9 global_irq 9 high level)
ACPI: IRQ0 used by override.
ACPI: IRQ2 used by override.
ACPI: IRQ9 used by override.
ACPI: HPET id: 0x8086a201 base: 0xfed00000
Using ACPI (MADT) for SMP configuration information
ACPI: Core revision 20060707
ACPI: Looking for DSDT in initramfs... /DSDT.aml does not exist.
ACPI: bus type pci registered
ACPI: Interpreter enabled
ACPI: Using IOAPIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (0000:00)
PCI quirk: region 1000-107f claimed by ICH6 ACPI/GPIO/TCO
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.RP01._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.RP03._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.RP04._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.PCIB._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs 1 5 *6 10 12 14 15)
ACPI: PCI Interrupt Link [LNKB] (IRQs 1 5 6 *11 12 14 15)
ACPI: PCI Interrupt Link [LNKC] (IRQs 1 5 6 10 12 14 15) *11
ACPI: PCI Interrupt Link [LNKD] (IRQs 1 5 6 11 12 14 15) *10
ACPI: PCI Interrupt Link [LNKE] (IRQs 1 5 6 *10 12 14 15)
ACPI: PCI Interrupt Link [LNKF] (IRQs 1 5 6 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [LNKG] (IRQs 1 5 6 *10 12 14 15)
ACPI: PCI Interrupt Link [LNKH] (IRQs 1 *5 6 11 12 14 15)
ACPI: Embedded Controller [EC0] (gpe 25) interrupt mode.
pnp: PnP ACPI init
pnp: PnP ACPI: found 10 devices
PnPBIOS: Disabled by ACPI PNP
PCI: Using ACPI for IRQ routing
ACPI: PCI Interrupt 0000:00:1c.0[A] -> GSI 17 (level, low) -> IRQ 169
ACPI: PCI Interrupt 0000:00:1c.2[C] -> GSI 18 (level, low) -> IRQ 177
ACPI: PCI Interrupt 0000:00:1c.3[D] -> GSI 19 (level, low) -> IRQ 185
ACPI: (supports S0 S3 S4 S5)
ACPI: PCI Interrupt 0000:00:1f.1[B] -> GSI 19 (level, low) -> IRQ 185
ACPI: PCI Interrupt 0000:00:1f.2[B] -> GSI 19 (level, low) -> IRQ 185
ACPI: Power Button (FF) [PWRF]
ACPI: Lid Switch [LID]
ACPI: Sleep Button (CM) [SLPB]
ACPI: Power Button (CM) [PWRB]
ACPI: PCI Interrupt 0000:00:1d.0[A] -> GSI 23 (level, low) -> IRQ 233
ACPI: PCI Interrupt 0000:00:1d.1[B] -> GSI 19 (level, low) -> IRQ 185
ACPI: PCI Interrupt 0000:00:1d.2[C] -> GSI 18 (level, low) -> IRQ 177
ACPI: PCI Interrupt 0000:00:1d.3[D] -> GSI 16 (level, low) -> IRQ 50
ACPI: PCI Interrupt 0000:00:1d.7[A] -> GSI 23 (level, low) -> IRQ 233
ACPI: PCI Interrupt 0000:00:1f.3[B] -> GSI 19 (level, low) -> IRQ 185
ACPI: PCI Interrupt 0000:06:00.1[A] -> GSI 20 (level, low) -> IRQ 58
ACPI: PCI Interrupt 0000:04:00.0[A] -> GSI 18 (level, low) -> IRQ 177
ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 66
ACPI: AC Adapter [ACAD] (on-line)
--
С уважением,
Прокопьев Евгений
next prev parent reply other threads:[~2007-10-09 18:23 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-10-08 11:44 Eugene Prokopiev
2007-10-08 11:49 ` Igor Zubkov
2007-10-09 18:08 ` Eugene Prokopiev
2007-10-09 18:23 ` Eugene Prokopiev [this message]
2007-10-10 5:58 ` Eugene Prokopiev
2007-10-08 19:15 ` Peter Volkov
2007-10-09 18:05 ` Eugene Prokopiev
2007-10-10 12:34 ` Андрей Черепанов
2007-10-08 19:17 ` Maxim Bodyansky
2007-10-09 7:13 ` ABATAPA
2007-10-09 17:51 ` Eugene Prokopiev
2007-10-10 11:11 ` Michael Shigorin
2007-10-11 6:49 ` ABATAPA
2007-10-11 8:39 ` Eugene Prokopiev
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=470BC705.8000508@stc.donpac.ru \
--to=prokopiev@stc.donpac.ru \
--cc=community@lists.altlinux.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
ALT Linux Community general discussions
This inbox may be cloned and mirrored by anyone:
git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git
# If you have public-inbox 1.1+ installed, you may
# initialize and index your mirror using the following commands:
public-inbox-init -V2 community community/ http://lore.altlinux.org/community \
mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com
public-inbox-index community
Example config snippet for mirrors.
Newsgroup available over NNTP:
nntp://lore.altlinux.org/org.altlinux.lists.community
AGPL code for this site: git clone https://public-inbox.org/public-inbox.git