From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Message-ID: <3A656996.840BBE2@asplinux.ru> From: Viacheslav Kaloshin X-Mailer: Mozilla 4.76 [en] (X11; U; Linux 2.2.16-22smp i686) X-Accept-Language: en MIME-Version: 1.0 To: mandrake-russian@linuxteam.iplabs.ru Subject: Re: [mdk-re] =?koi8-r?Q?=D0=D2=CF=20=F7=CE=C5=DB=CE=C9=CA?= SCSI References: <20010117123204.A2691@acma.rh> Content-Type: text/plain; charset=koi8-r Content-Transfer-Encoding: 8bit Sender: mandrake-russian-admin@linuxteam.iplabs.ru Errors-To: mandrake-russian-admin@linuxteam.iplabs.ru X-BeenThere: mandrake-russian@linuxteam.iplabs.ru X-Mailman-Version: 2.0 Precedence: bulk Reply-To: mandrake-russian@linuxteam.iplabs.ru List-Help: List-Post: List-Subscribe: , List-Id: Mandrake/RE discussion list List-Unsubscribe: , List-Archive: Date: Wed Jan 17 12:39:00 2001 X-Original-Date: Wed, 17 Jan 2001 12:44:54 +0300 Archived-At: List-Archive: Kataev Andrey wrote: > > Добрый день! Имеется девайс, включающий в себя два сказевых диска, > они видятся как два диска, но fdisk говорит след: > > fdisk /dev/sdb > Device contains neither a valid DOS partition table, nor Sun, SGI or OSF disklabel > Building a new DOS disklabel. Changes will remain in memory only, > until you decide to write them. After that, of course, the previous > content won't be recoverable. > > Segmentation fault > > соответстввенно ничего не монтируется и не пашет :( > Куда рыть? > > proc/scsi/scsi > > Attached devices: > Host: scsi0 Channel: 00 Id: 01 Lun: 00 > Vendor: SEAGATE Model: ST34572W Rev: 0784 > Type: Direct-Access ANSI SCSI revision: 02 > Host: scsi0 Channel: 00 Id: 02 Lun: 00 > Vendor: SEAGATE Model: ST34572W Rev: 0784 > Type: Direct-Access ANSI SCSI revision: 02 > proc/scsi/ncr53c8xx/0 > General information: > Chip NCR53C895, device id 0xc, revision id 0x1 > IO port address 0xd000, IRQ number 11 > Using memory mapped IO at virtual address 0xc3819000 > Synchronous period factor 10, max commands per lun 32 > Profiling information: > num_trans = 18 > num_kbytes = 32 > num_disc = 14 > num_break = 2 > num_int = 36 > num_fly = 18 > ms_setup = 20 > ms_data = 10 > ms_disc = 110 > ms_post = 0 > > 2.2.14-12bc > > Кто виноват? fdisk?, kernel?, /dev/hands? 99% - ядро. У меня примерно такое же было, когда винты подключал - то ядро не грузится, то еще как ерепенится. Вылечилось уходом на 2.2.17. Правда, у меня адаптековский контроллер был ... -- With best wishes, Viacheslav Kaloshin multik@asplinux.ru tel. +7 095 722-4529 http://linuxnews.ru