From: Alisher <alisher_faiz@rambler.ru> To: community@lists.altlinux.org Subject: [Comm] wifi+branch5.1 Date: Tue, 15 Dec 2009 21:47:02 +0000 Message-ID: <200912152147.02792.alisher_faiz@rambler.ru> (raw) [-- Attachment #1: Type: text/plain, Size: 1626 bytes --] Здравствуйте. Пытаюсь настроить линукс-роутер с wifi, но не получается. Есть карточка edimax ew-7126 на чипе realtek 8081 lspci -vv: 04:04.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8180L 802.11b MAC (rev 20) Subsystem: Realtek Semiconductor Co., Ltd. RTL8180L 802.11b MAC Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 32 (8000ns min, 16000ns max), Cache Line Size: 32 bytes Interrupt: pin A routed to IRQ 17 Region 0: I/O ports at 9c00 [size=256] Region 1: Memory at fdaff000 (32-bit, non-prefetchable) [size=256] Capabilities: [50] Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=375mA PME(D0-,D1+,D2+,D3hot+,D3cold+) Status: D0 PME-Enable- DSel=0 DScale=0 PME- Kernel driver in use: rtl8180 Kernel modules: rtl8180 Не могу понять чего не хватает: # ifconfig wlan0 down # iwconfig wlan0 mode Master channel 1 essid "MyNet" Error for wireless request "Set Mode" (8B06) : SET failed on device wlan0 ; Invalid argument. Выводы lsmod,ifconfig и iwconfig во вложении. [-- Attachment #2: realtek_8081.txt --] [-- Type: text/plain, Size: 7446 bytes --] # iwconfig lo no wireless extensions. eth0 no wireless extensions. wmaster0 no wireless extensions. wlan0 IEEE 802.11b ESSID:"" Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated Tx-Power=27 dBm Retry min limit:7 RTS thr:off Fragment thr:off Encryption key:off Power Management:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 pan0 no wireless extensions. vboxnet0 no wireless extensions. ppp0 no wireless extensions. [root@localhost ~]# ifconfig lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:5739 errors:0 dropped:0 overruns:0 frame:0 TX packets:5739 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:1122255 (1.0 MiB) TX bytes:1122255 (1.0 MiB) ppp0 Link encap:Point-to-Point Protocol inet addr:10.16.184.243 P-t-P:10.6.6.6 Mask:255.255.255.255 UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1 RX packets:583 errors:0 dropped:0 overruns:0 frame:0 TX packets:726 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:3 RX bytes:495258 (483.6 KiB) TX bytes:82769 (80.8 KiB) wlan0 Link encap:Ethernet HWaddr 00:50:FC:BD:0D:F1 UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) wmaster0 Link encap:UNSPEC HWaddr 00-50-FC-BD-0D-F1-58-04-00-00-00-00-00-00-00-00 UP RUNNING MTU:0 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) [root@localhost ~]# lsmod Module Size Used by ppp_deflate 4524 0 zlib_deflate 19960 1 ppp_deflate bsd_comp 5516 0 ppp_async 8684 1 crc_ccitt 1868 1 ppp_async ppp_generic 25280 7 ppp_deflate,bsd_comp,ppp_async slhc 6188 1 ppp_generic rndis_wlan 22004 0 rndis_host 7436 1 rndis_wlan cdc_ether 5004 1 rndis_host usbnet 16660 3 rndis_wlan,rndis_host,cdc_ether cdc_acm 15488 3 ppdev 7344 0 parport_pc 36452 0 lp 9604 0 parport 34764 3 ppdev,parport_pc,lp binfmt_misc 8020 1 nvidia 8873668 38 vboxnetadp 81896 0 vboxnetflt 88680 0 vboxdrv 123592 1 vboxnetflt bridge 48288 0 stp 2288 1 bridge bnep 12076 2 sco 10000 2 l2cap 22764 3 bnep bluetooth 53828 5 bnep,sco,l2cap af_packet 17644 2 jfs 176324 2 nls_base 7056 1 jfs dm_mod 56708 0 snd_hda_codec_realtek 197616 1 snd_hda_intel 25928 4 arc4 1676 2 snd_hda_codec 75148 2 snd_hda_codec_realtek,snd_hda_intel ecb 2572 2 rtl8180 28652 0 snd_hwdep 7056 1 snd_hda_codec snd_pcm 74096 2 snd_hda_intel,snd_hda_codec snd_timer 20788 1 snd_pcm snd 58180 14 snd_hda_codec_realtek,snd_hda_intel,snd_hda_codec,snd_hwdep,snd_pcm,snd_timer mac80211 170504 1 rtl8180 psmouse 56132 0 soundcore 7072 1 snd ehci_hcd 35096 0 eeprom_93cx6 1964 1 rtl8180 uhci_hcd 22044 0 snd_page_alloc 8852 2 snd_hda_intel,snd_pcm serio_raw 5296 0 usbcore 149232 8 rndis_wlan,rndis_host,cdc_ether,usbnet,cdc_acm,ehci_hcd,uhci_hcd cfg80211 64556 2 rtl8180,mac80211 via_agp 8044 1 pcspkr 2316 0 via_rhine 21652 0 agpgart 34796 2 nvidia,via_agp evdev 9472 7 mii 5132 2 usbnet,via_rhine i2c_viapro 7424 0 i2c_core 23584 2 nvidia,i2c_viapro ide_cd_mod 27952 0 rtc_cmos 10316 0 rtc_core 17608 1 rtc_cmos rtc_lib 2860 1 rtc_core fan 4144 0 processor 34496 0 sg 28640 0 cdrom 34752 1 ide_cd_mod thermal 12808 0 button 5244 0 ext3 126868 3 jbd 46048 1 ext3 mbcache 7568 1 ext3 ata_generic 4624 0 pata_via 9268 0 pata_acpi 3980 0 sata_via 9136 6 libata 174732 4 ata_generic,pata_via,pata_acpi,sata_via sd_mod 34856 8 crc_t10dif 1708 1 sd_mod scsi_mod 150996 3 sg,libata,sd_mod ide_gd_mod 23344 0 ide_generic 1936 0 [permanent] via82cxxx 6768 0 ide_pci_generic 3888 0 ide_core 103592 5 ide_cd_mod,ide_gd_mod,ide_generic,via82cxxx,ide_pci_generic
reply other threads:[~2009-12-15 21:47 UTC|newest] Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=200912152147.02792.alisher_faiz@rambler.ru \ --to=alisher_faiz@rambler.ru \ --cc=community@lists.altlinux.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: link
ALT Linux Community general discussions This inbox may be cloned and mirrored by anyone: git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git # If you have public-inbox 1.1+ installed, you may # initialize and index your mirror using the following commands: public-inbox-init -V2 community community/ http://lore.altlinux.org/community \ mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com public-inbox-index community Example config snippet for mirrors. Newsgroup available over NNTP: nntp://lore.altlinux.org/org.altlinux.lists.community AGPL code for this site: git clone https://public-inbox.org/public-inbox.git