From: Maxim Tyurin <mrkooll@tdr.pibhe.com> To: ALTLinux community <community@altlinux.ru> Cc: ALTLinux Castle <castle@altlinux.ru> Subject: [Comm] Проблемы с четырьмя сетевыми 3C905C-TX Date: Wed, 18 Jun 2003 19:24:14 +0300 Message-ID: <20030618162414.GC31421@mrkooll.tdr.pibhe.com> (raw) [-- Attachment #1: Type: text/plain, Size: 5949 bytes --] Hi! Стоит у меня шлюз с 3-мя сетевыми карточками 3COM 3C905C-TX и нормально работает. Понадобилось поставить еще одну. После установки интерфейс вроде-как поднимается но не работает. Вот вывод ifconfig eth0 Link encap:Ethernet HWaddr 00:04:79:67:0A:74 inet addr:192.168.50.1 Bcast:192.168.50.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:32220 errors:1 dropped:1 overruns:1 frame:0 TX packets:8195 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:32507367 (31.0 Mb) TX bytes:1683634 (1.6 Mb) Interrupt:11 Base address:0xbc00 eth1 Link encap:Ethernet HWaddr 00:04:79:67:09:88 inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:277 errors:0 dropped:0 overruns:0 frame:0 TX packets:123 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:26062 (25.4 Kb) TX bytes:15791 (15.4 Kb) Interrupt:10 Base address:0xc000 eth2 Link encap:Ethernet HWaddr 00:04:79:67:0A:22 inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:2459 errors:0 dropped:0 overruns:0 frame:0 TX packets:2860 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:874749 (854.2 Kb) TX bytes:417282 (407.5 Kb) Interrupt:11 Base address:0xc400 eth3 Link encap:Ethernet HWaddr 00:04:79:67:09:F4 inet addr:10.0.0.2 Bcast:10.255.255.255 Mask:255.0.0.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:1 errors:0 dropped:0 overruns:0 frame:0 TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:1514 (1.4 Kb) TX bytes:1694 (1.6 Kb) Interrupt:10 Base address:0xc800 eth0,eth1,eth2 работают eth3 даже не пингуется ping 10.0.0.2 PING 10.0.0.2 (10.0.0.2) from 10.0.0.2 : 56(84) bytes of data. ping: sendto: Operation not permitted ping: sendto: Operation not permitted ping: sendto: Operation not permitted --- 10.0.0.2 ping statistics --- 3 packets transmitted, 0 packets received, 100% packet loss Пытался ставить другие сетевые (Intel и Realtek) все равно работает только первые 3 карточки. Менял драйвера (пробовал и 3c59x и 3c90x) Правда карточки сидят по двое на одном прерывании cat /proc/interrupts CPU0 0: 227957 XT-PIC timer 1: 843 XT-PIC keyboard 2: 0 XT-PIC cascade 8: 1 XT-PIC rtc 10: 456 XT-PIC eth1, eth3 11: 56113 XT-PIC eth0, eth2 но eth0 и eth2 сидя на одном прерывании работают как часы. Кроме того 3c5x9setup не дает выставить irq На попытку выставить irq в /etc/lilo.conf никакой реакции. Как можно решить такую проблему и заставить работать больше 3-х сетевых карт? Машина на которой это все стоит - AthlonXP на EPoX 8K7A (чипсет AMD 761) Система - Castle, ядро 2.4.7-up-rsbac Вот еще часть вывода lspci -vx 00:09.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 74) Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC Management NIC Flags: bus master, medium devsel, latency 32, IRQ 11 I/O ports at bc00 [size=128] Memory at ec105000 (32-bit, non-prefetchable) [size=128] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: [dc] Power Management version 2 00: b7 10 00 92 07 00 10 02 74 00 00 02 08 20 00 00 10: 01 bc 00 00 00 50 10 ec 00 00 00 00 00 00 00 00 20: 00 00 00 00 00 00 00 00 00 00 00 00 b7 10 00 10 30: 00 00 00 00 dc 00 00 00 00 00 00 00 0b 01 0a 0a 00:0a.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 74) Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC Management NIC Flags: bus master, medium devsel, latency 32, IRQ 10 I/O ports at c000 [size=128] Memory at ec101000 (32-bit, non-prefetchable) [size=128] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: [dc] Power Management version 2 00: b7 10 00 92 07 00 10 02 74 00 00 02 08 20 00 00 10: 01 c0 00 00 00 10 10 ec 00 00 00 00 00 00 00 00 20: 00 00 00 00 00 00 00 00 00 00 00 00 b7 10 00 10 30: 00 00 00 00 dc 00 00 00 00 00 00 00 0a 01 0a 0a 00:0b.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 74) Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC Management NIC Flags: bus master, medium devsel, latency 32, IRQ 11 I/O ports at c400 [size=128] Memory at ec102000 (32-bit, non-prefetchable) [size=128] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: [dc] Power Management version 2 00: b7 10 00 92 07 00 10 02 74 00 00 02 08 20 00 00 10: 01 c4 00 00 00 20 10 ec 00 00 00 00 00 00 00 00 20: 00 00 00 00 00 00 00 00 00 00 00 00 b7 10 00 10 30: 00 00 00 00 dc 00 00 00 00 00 00 00 0b 01 0a 0a 00:0c.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 74) Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC Management NIC Flags: bus master, medium devsel, latency 32, IRQ 10 I/O ports at c800 [size=128] Memory at ec103000 (32-bit, non-prefetchable) [size=128] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: [dc] Power Management version 2 00: b7 10 00 92 07 00 10 02 74 00 00 02 08 20 00 00 10: 01 c8 00 00 00 30 10 ec 00 00 00 00 00 00 00 00 20: 00 00 00 00 00 00 00 00 00 00 00 00 b7 10 00 10 30: 00 00 00 00 dc 00 00 00 00 00 00 00 0a 01 0a 0a -- With Best Regards, Maxim Tyurin JID: MrKooll@jabber.pibhe.com [-- Attachment #2: Type: application/pgp-signature, Size: 189 bytes --]
reply other threads:[~2003-06-18 16:24 UTC|newest] Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=20030618162414.GC31421@mrkooll.tdr.pibhe.com \ --to=mrkooll@tdr.pibhe.com \ --cc=castle@altlinux.ru \ --cc=community@altlinux.ru \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: link
ALT Linux Community general discussions This inbox may be cloned and mirrored by anyone: git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git # If you have public-inbox 1.1+ installed, you may # initialize and index your mirror using the following commands: public-inbox-init -V2 community community/ http://lore.altlinux.org/community \ mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com public-inbox-index community Example config snippet for mirrors. Newsgroup available over NNTP: nntp://lore.altlinux.org/org.altlinux.lists.community AGPL code for this site: git clone https://public-inbox.org/public-inbox.git