From: sinom <sinom@ktk.ru>
To: community@altlinux.ru
Subject: Re: [Comm] cdrecord _NEC
Date: Fri, 30 May 2003 10:03:08 +0800
Message-ID: <200305300951.04093.sinom@ktk.ru> (raw)
In-Reply-To: <20030529214501.227f337a.sssku@online.ru>
> > $ cdrecord -v dev=0,0,0 music.iso
> >
> > Identifikation : 'CD-RW NR-9300A '
> >
> > Manufacturer: CMC Magnetics Corporation
> >
> > error (ultra-dma/32)) Fru 0x0
> >
> > Вопрос стандартный. Что делать?
>
> Ничего не написали, для какой скорости записи предназначены
> диски. Может быть, для начала взять диски "помедленнее"?
>
Скорость болванок роли не играет. Пробовал разные, с различными скоростями, и
пытался писал на них тоже разными скоростями. Все одно. Например:
$ cdrecord -v -eject speed=2 dev=0,0,0 music.iso
Cdrecord 2.0 (i586-alt-linux-gnu) Copyright (C) 1995-2002 JЖrg Schilling
TOC Type: 1 = CD-ROM
scsidev: '0,0,0'
scsibus: 0 target: 0 lun: 0
Linux sg driver version: 3.1.24
Using libscg version 'schily-0.7'
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 2
Capabilities :
Vendor_info : '_NEC '
Identifikation : 'CD-RW NR-9300A '
Revision : '2.12'
Device seems to be: Generic mmc CD-RW.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R
Drive buf size : 1226752 = 1198 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 638 MB
Total size: 732 MB (72:35.57) = 326668 sectors
Lout start: 733 MB (72:37/43) = 326668 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Reference speed: 2
Is not unrestricted
Is erasable
ATIP start of lead in: -11635 (97:26/65)
ATIP start of lead out: 359849 (79:59/74)
1T speed low: 0 (reserved val 0) 1T speed high: 4
2T speed low: 8 2T speed high: 0 (reserved val 10)
power mult factor: 4 6
recommended erase/write power: 3
A1 values: 02 4C B0
A2 values: 4A C8 36
Disk type: Phase change
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 33181
Starting to write CD/DVD at speed 4 in real TAO mode for single session.
Last chance to quit, starting real write 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is OFF.
Performing OPC...
Starting new track at sector: 0
Track 01: 1 of 638 MB written (fifo 93%) [buf 89%] 82.7x.cdrecord:
Input/output error. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 00 02 AA 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 04 00 00 00 00 0A 00 00 00 00 08 03 00 00
Sense Key: 0x4 Hardware Error, Segment 0
Sense Code: 0x08 Qual 0x03 (logical unit communication crc error
(ultra-dma/32)) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.103s timeout 40s
write track data: error after 1396736 bytes
Sense Bytes: 70 00 00 00 00 00 00 0A 00 00 00 00 00 00 00 00 00 00
Writing time: 11.440s
Average write speed 662.3x.
Fixating...
Fixating time: 62.600s
cdrecord: fifo had 86 puts and 23 gets.
cdrecord: fifo was 0 times empty and 5 times full, min fill was 85%.
--------------------------------------------------------------------------
При попытке записи K3B говорит следующее (кнопка Show Debugging Output):
cdrecord
-----------------------
scsidev: '0,0,0'
scsibus: 0 target: 0 lun: 0
Linux sg driver version: 3.1.24
Cdrecord 2.0 (i586-alt-linux-gnu) Copyright (C) 1995-2002 JЖrg Schilling
TOC Type: 1 = CD-ROM
Using libscg version 'schily-0.7'
Driveropts: 'burnfree'
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 2
Capabilities :
Vendor_info : '_NEC '
Identifikation : 'CD-RW NR-9300A '
Revision : '2.12'
Device seems to be: Generic mmc CD-RW.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R
Drive buf size : 1226752 = 1198 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 670 MB
Total size: 769 MB (76:14.08) = 343056 sectors
Lout start: 769 MB (76:16/06) = 343056 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Reference speed: 2
Is not unrestricted
Is erasable
ATIP start of lead in: -11635 (97:26/65)
ATIP start of lead out: 359849 (79:59/74)
1T speed low: 0 (reserved val 0) 1T speed high: 4
2T speed low: 8 2T speed high: 0 (reserved val 10)
power mult factor: 4 6
recommended erase/write power: 3
A1 values: 02 4C B0
A2 values: 4A C8 36
Disk type: Phase change
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 16793
Starting to write CD/DVD at speed 4 in real SAO mode for single session.
Last chance to quit, starting real write in 2 seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is OFF.
Turning BURN-Free on
Performing OPC...
Sending CUE sheet...
/usr/bin/cdrecord: WARNING: Drive returns wrong startsec (0) using -150
Writing pregap for track 1 at -150
Starting new track at sector: 0
Track 01: 0 of 670 MB written.
/usr/bin/cdrecord: Input/output error. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 00 01 74 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 04 00 00 00 00 0A 00 00 00 00 08 03 00 00
Sense Key: 0x4 Hardware Error, Segment 0
Sense Code: 0x08 Qual 0x03 (logical unit communication crc error
(ultra-dma/32)) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 3.817s timeout 200s
write track data: error after 761856 bytes
Writing time: 14.270s
Average write speed 510.5x.
Fixating...
Sense Bytes: 70 00 00 00 00 00 00 0A 00 00 00 00 00 00 00 00 00 00
/usr/bin/cdrecord: Input/output error. flush cache: scsi sendcmd: no error
CDB: 35 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: F0 00 03 00 00 01 75 0A 00 00 00 00 0C 07 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x0C Qual 0x07 (write error - recovery needed) Fru 0x0
Sense flags: Blk 373 (valid)
cmd finished after 31.997s timeout 200s
Trouble flushing the cache
Fixating time: 31.999s
BURN-Free was never needed.
/usr/bin/cdrecord: fifo had 76 puts and 13 gets.
/usr/bin/cdrecord: fifo was 0 times empty and 1 times full, min fill was 81%.
mkisofs
-----------------------
0.15% done, estimate finish Fri May 30 10:08:42 2003
0.29% done, estimate finish Fri May 30 10:03:08 2003
0.44% done, estimate finish Fri May 30 10:01:12 2003
0.59% done, estimate finish Fri May 30 10:00:16 2003
next prev parent reply other threads:[~2003-05-30 2:03 UTC|newest]
Thread overview: 18+ messages / expand[flat|nested] mbox.gz Atom feed top
2003-05-29 15:21 sinom
2003-05-29 17:45 ` Sergey S. Skulachenko
2003-05-30 2:03 ` sinom [this message]
2003-05-30 17:01 ` Gleb Kulikov
2003-05-30 3:34 ` Mike Lykov
2003-05-30 9:59 ` sinom
2003-05-30 10:22 ` Владимир
2003-05-30 10:42 ` Antonio
2003-05-31 10:07 ` Re[2]: " metalking
2003-06-02 8:23 ` Antonio
2003-05-30 10:29 ` Dmitry Kovalsky
2003-05-30 10:59 ` Aleksey Korotkov
2003-05-30 6:47 ` Antonio
2003-05-30 18:29 ` Sergey S. Skulachenko
2003-06-01 9:34 ` [Comm] " Oleg N. Kayunov
2003-06-01 12:39 ` Maxim Tyurin
2003-06-06 6:36 ` Oleg N. Kayunov
2003-06-06 7:13 ` Antonio
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=200305300951.04093.sinom@ktk.ru \
--to=sinom@ktk.ru \
--cc=community@altlinux.ru \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
ALT Linux Community general discussions
This inbox may be cloned and mirrored by anyone:
git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git
# If you have public-inbox 1.1+ installed, you may
# initialize and index your mirror using the following commands:
public-inbox-init -V2 community community/ http://lore.altlinux.org/community \
mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com
public-inbox-index community
Example config snippet for mirrors.
Newsgroup available over NNTP:
nntp://lore.altlinux.org/org.altlinux.lists.community
AGPL code for this site: git clone https://public-inbox.org/public-inbox.git