From: sinom <sinom@ktk.ru> To: <community@altlinux.ru> Subject: [Comm] cdrecord _NEC Date: Thu, 29 May 2003 23:21:31 +0800 Message-ID: <200305292321.31754.sinom@ktk.ru> (raw) Здравствуйте! Сегодня приобрел резак фирмы NEC. В lilo.conf прописал append="hdb=ide-scsi" после чего появилось: $ cdrecord -scanbus Cdrecord 2.0 (i586-alt-linux-gnu) Copyright (C) 1995-2002 JЖrg Schilling Linux sg driver version: 3.1.24 Using libscg version 'schily-0.7' scsibus0: 0,0,0 0) '_NEC ' 'CD-RW NR-9300A ' '2.12' Removable CD-ROM 0,1,0 1) * 0,2,0 2) * 0,3,0 3) * 0,4,0 4) * 0,5,0 5) * 0,6,0 6) * 0,7,0 7) * При попытке что-либо писать пишет только первые несколько мегобайт, после чего вылетает с ошибкой. После этого, например, можно просмотреть первае несколько секунд фильма, или прослушать первую _часть_ mp3. Вот что говорит: $ cdrecord -v dev=0,0,0 music.iso Cdrecord 2.0 (i586-alt-linux-gnu) Copyright (C) 1995-2002 JЖrg Schilling TOC Type: 1 = CD-ROM scsidev: '0,0,0' scsibus: 0 target: 0 lun: 0 Linux sg driver version: 3.1.24 Using libscg version 'schily-0.7' atapi: 1 Device type : Removable CD-ROM Version : 0 Response Format: 2 Capabilities : Vendor_info : '_NEC ' Identifikation : 'CD-RW NR-9300A ' Revision : '2.12' Device seems to be: Generic mmc CD-RW. Using generic SCSI-3/mmc CD-R driver (mmc_cdr). Driver flags : MMC-3 SWABAUDIO BURNFREE Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R Drive buf size : 1226752 = 1198 KB FIFO size : 4194304 = 4096 KB Track 01: data 638 MB Total size: 732 MB (72:35.57) = 326668 sectors Lout start: 733 MB (72:37/43) = 326668 sectors Current Secsize: 2048 ATIP info from disk: Indicated writing power: 5 Reference speed: 2 Is not unrestricted Is erasable ATIP start of lead in: -11635 (97:26/65) ATIP start of lead out: 359849 (79:59/74) 1T speed low: 0 (reserved val 0) 1T speed high: 4 2T speed low: 8 2T speed high: 0 (reserved val 10) power mult factor: 4 6 recommended erase/write power: 3 A1 values: 02 4C B0 A2 values: 4A C8 36 Disk type: Phase change Manuf. index: 3 Manufacturer: CMC Magnetics Corporation Blocks total: 359849 Blocks current: 359849 Blocks remaining: 33181 Starting to write CD/DVD at speed 4 in real TAO mode for single session. Last chance to quit, starting real write 0 seconds. Operation starts. Waiting for reader process to fill input buffer ... input buffer ready. BURN-Free is OFF. Performing OPC... Starting new track at sector: 0 Track 01: 1 of 638 MB written (fifo 96%) [buf 89%] 112.8x.cdrecord: Input/output error. write_g1: scsi sendcmd: no error CDB: 2A 00 00 00 02 6C 00 00 1F 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 04 00 00 00 00 0A 00 00 00 00 08 03 00 00 Sense Key: 0x4 Hardware Error, Segment 0 Sense Code: 0x08 Qual 0x03 (logical unit communication crc error (ultra-dma/32)) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 1.389s timeout 40s write track data: error after 1269760 bytes Sense Bytes: 70 00 00 00 00 00 00 0A 00 00 00 00 00 00 00 00 00 00 Writing time: 11.500s Average write speed 651.2x. Fixating... Fixating time: 62.569s cdrecord: fifo had 84 puts and 21 gets. cdrecord: fifo was 0 times empty and 2 times full, min fill was 85%. Вопрос стандартный. Что делать? З.Ы. Система Мастер2.2 -- Роман
next reply other threads:[~2003-05-29 15:21 UTC|newest] Thread overview: 18+ messages / expand[flat|nested] mbox.gz Atom feed top 2003-05-29 15:21 sinom [this message] 2003-05-29 17:45 ` Sergey S. Skulachenko 2003-05-30 2:03 ` sinom 2003-05-30 17:01 ` Gleb Kulikov 2003-05-30 3:34 ` Mike Lykov 2003-05-30 9:59 ` sinom 2003-05-30 10:22 ` Владимир 2003-05-30 10:42 ` Antonio 2003-05-31 10:07 ` Re[2]: " metalking 2003-06-02 8:23 ` Antonio 2003-05-30 10:29 ` Dmitry Kovalsky 2003-05-30 10:59 ` Aleksey Korotkov 2003-05-30 6:47 ` Antonio 2003-05-30 18:29 ` Sergey S. Skulachenko 2003-06-01 9:34 ` [Comm] " Oleg N. Kayunov 2003-06-01 12:39 ` Maxim Tyurin 2003-06-06 6:36 ` Oleg N. Kayunov 2003-06-06 7:13 ` Antonio
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=200305292321.31754.sinom@ktk.ru \ --to=sinom@ktk.ru \ --cc=community@altlinux.ru \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: link
ALT Linux Community general discussions This inbox may be cloned and mirrored by anyone: git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git # If you have public-inbox 1.1+ installed, you may # initialize and index your mirror using the following commands: public-inbox-init -V2 community community/ http://lore.altlinux.org/community \ mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com public-inbox-index community Example config snippet for mirrors. Newsgroup available over NNTP: nntp://lore.altlinux.org/org.altlinux.lists.community AGPL code for this site: git clone https://public-inbox.org/public-inbox.git