ALT Linux Community general discussions
 help / color / mirror / Atom feed
* [Comm] две проблеммы!
@ 2003-04-21 10:26 Петров А.В.
  2003-04-21 11:34 ` Antonio
  2003-04-21 12:47 ` [Comm] " Sergey Vlasov
  0 siblings, 2 replies; 7+ messages in thread
From: Петров А.В. @ 2003-04-21 10:26 UTC (permalink / raw)
  To: ALTLinux

Добрый день всем!

Вот проблемки возникли. ALT Linux Junior 2.1

[1]

При начальной загрузке в сообщениях выдаются ошибочки с hda и hdb. При этом 
диск hdb работает нормально, а вот hda тормозит

[root@localhost sbin]# hdparm -t /dev/hda

/dev/hda:
 Timing buffered disk reads:  64 MB in  2.89 seconds = 22.15 MB/sec

IMHO, не очень быстрая скорость. Должно быть где-то около 40 с UDMA66 (если я 
конечно не ошибаюсь)

все вроде включено с помошью hdparm -d1 -X67 -u1 -c1 -m16 -k1 

может с поддержкой чипсета что-то не так (чипчсет AMD Irongate индекс если не 
ошибаюсь 751 - это под самый первый Slot A Athlon ;-) )

а вот что выдается по dmesg. Что это за ошибочки - { DriveReady SeekComplete 
Error }? и чем это грозит добропорядочному пользователю :-) ??? 

[.... skiped ....]
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt82c686a (rev 1b) IDE UDMA66 controller on pci00:04.1
    ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA
    ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:pio, hdd:pio
hda: IBM-DPTA-372050, ATA DISK drive
hdb: ATAPI CD-ROM DRIVE 40X MAXIMUM, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 40088160 sectors (20525 MB) w/1961KiB Cache, CHS=2495/255/63, UDMA(66)

[.... skiped ....]

ReiserFS version 3.6.25
VFS: Mounted root (reiserfs filesystem) readonly.
change_root: old root has d_count=2
Trying to unmount old root ... okay
Freeing unused kernel memory: 752k freed
hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error }
hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC }
Warning: unable to open an initial console.
Executing init=/sbin/init
hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error }
hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC }
hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error }
hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC }
hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error }
hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC }
hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error }
hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC }

[.... skipd ....]

[drm] AGP 0.99 on AMD Irongate @ 0xe8000000 64MB
[drm] Initialized r128 2.2.0 20010917 on minor 0
hdb: ATAPI 40X CD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
hdb: packet command error: status=0x51<4> { DriveReady SeekComplete Error }
hdb: packet command error: error=0x50
ATAPI device hdb:
  Error: Illegal request -- (Sense key=0x05)
  Invalid command operation code -- (asc=0x20, ascq=0x00)
  The failed "Get Configuration" packet command was:
  "46 02 00 1e 00 00 00 00 08 00 00 00 "
hdb: packet command error: status=0x51<4> { DriveReady SeekComplete Error }
hdb: packet command error: error=0x50
ATAPI device hdb:
  Error: Illegal request -- (Sense key=0x05)
  Invalid command operation code -- (asc=0x20, ascq=0x00)
  The failed "Read Table of Contents" packet command was:
  "43 00 05 00 00 00 00 00 04 00 00 00 "


[2]

Вторая проблемка со сканером Mustek 1200 UB Plus (USB). Вот что пишется при 
начальной загрузке. 
Вопрос: как заставить его работать?

usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 18:05:07 Oct  1 2002
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 10 for device 00:04.3
PCI: Sharing IRQ 10 with 00:04.2
usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Found IRQ 10 for device 00:04.2
PCI: Sharing IRQ 10 with 00:04.3
usb-uhci.c: USB UHCI at I/O 0xd000, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
hub.c: USB new device connect on bus2/2, assigned device number 2
usb.c: USB device 2 (vend/prod 0x5d8/0x4002) is not claimed by any active 
driver
.


-- 
Петров А.В.	
------------------
пишите на dreamer@aport.ru


^ permalink raw reply	[flat|nested] 7+ messages in thread

end of thread, other threads:[~2003-04-22  6:40 UTC | newest]

Thread overview: 7+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2003-04-21 10:26 [Comm] две проблеммы! Петров А.В.
2003-04-21 11:34 ` Antonio
2003-04-21 14:03   ` Петров А.В.
2003-04-21 14:20     ` [Comm] " Sergey Vlasov
2003-04-22  5:52     ` [Comm] " Борис Ревякин
2003-04-22  6:40     ` Antonio
2003-04-21 12:47 ` [Comm] " Sergey Vlasov

ALT Linux Community general discussions

This inbox may be cloned and mirrored by anyone:

	git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 community community/ http://lore.altlinux.org/community \
		mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com
	public-inbox-index community

Example config snippet for mirrors.
Newsgroup available over NNTP:
	nntp://lore.altlinux.org/org.altlinux.lists.community


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git