From: "Петров А.В." <dreamer@aport.ru> To: ALTLinux <community@altlinux.ru> Subject: [Comm] две проблеммы! Date: Mon, 21 Apr 2003 14:26:43 +0400 Message-ID: <200304211426.43089.dreamer@aport.ru> (raw) Добрый день всем! Вот проблемки возникли. ALT Linux Junior 2.1 [1] При начальной загрузке в сообщениях выдаются ошибочки с hda и hdb. При этом диск hdb работает нормально, а вот hda тормозит [root@localhost sbin]# hdparm -t /dev/hda /dev/hda: Timing buffered disk reads: 64 MB in 2.89 seconds = 22.15 MB/sec IMHO, не очень быстрая скорость. Должно быть где-то около 40 с UDMA66 (если я конечно не ошибаюсь) все вроде включено с помошью hdparm -d1 -X67 -u1 -c1 -m16 -k1 может с поддержкой чипсета что-то не так (чипчсет AMD Irongate индекс если не ошибаюсь 751 - это под самый первый Slot A Athlon ;-) ) а вот что выдается по dmesg. Что это за ошибочки - { DriveReady SeekComplete Error }? и чем это грозит добропорядочному пользователю :-) ??? [.... skiped ....] ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: VIA vt82c686a (rev 1b) IDE UDMA66 controller on pci00:04.1 ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:pio, hdd:pio hda: IBM-DPTA-372050, ATA DISK drive hdb: ATAPI CD-ROM DRIVE 40X MAXIMUM, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: 40088160 sectors (20525 MB) w/1961KiB Cache, CHS=2495/255/63, UDMA(66) [.... skiped ....] ReiserFS version 3.6.25 VFS: Mounted root (reiserfs filesystem) readonly. change_root: old root has d_count=2 Trying to unmount old root ... okay Freeing unused kernel memory: 752k freed hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error } hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC } Warning: unable to open an initial console. Executing init=/sbin/init hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error } hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC } hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error } hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC } hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error } hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC } hda: dma_intr: status=0x51<4> { DriveReady SeekComplete Error } hda: dma_intr: error=0x84<4> { DriveStatusError BadCRC } [.... skipd ....] [drm] AGP 0.99 on AMD Irongate @ 0xe8000000 64MB [drm] Initialized r128 2.2.0 20010917 on minor 0 hdb: ATAPI 40X CD-ROM drive, 128kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.12 hdb: packet command error: status=0x51<4> { DriveReady SeekComplete Error } hdb: packet command error: error=0x50 ATAPI device hdb: Error: Illegal request -- (Sense key=0x05) Invalid command operation code -- (asc=0x20, ascq=0x00) The failed "Get Configuration" packet command was: "46 02 00 1e 00 00 00 00 08 00 00 00 " hdb: packet command error: status=0x51<4> { DriveReady SeekComplete Error } hdb: packet command error: error=0x50 ATAPI device hdb: Error: Illegal request -- (Sense key=0x05) Invalid command operation code -- (asc=0x20, ascq=0x00) The failed "Read Table of Contents" packet command was: "43 00 05 00 00 00 00 00 04 00 00 00 " [2] Вторая проблемка со сканером Mustek 1200 UB Plus (USB). Вот что пишется при начальной загрузке. Вопрос: как заставить его работать? usb.c: registered new driver usbdevfs usb.c: registered new driver hub usb-uhci.c: $Revision: 1.275 $ time 18:05:07 Oct 1 2002 usb-uhci.c: High bandwidth mode enabled PCI: Found IRQ 10 for device 00:04.3 PCI: Sharing IRQ 10 with 00:04.2 usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 10 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected PCI: Found IRQ 10 for device 00:04.2 PCI: Sharing IRQ 10 with 00:04.3 usb-uhci.c: USB UHCI at I/O 0xd000, IRQ 10 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected usb-uhci.c: v1.275:USB Universal Host Controller Interface driver hub.c: USB new device connect on bus2/2, assigned device number 2 usb.c: USB device 2 (vend/prod 0x5d8/0x4002) is not claimed by any active driver . -- Петров А.В. ------------------ пишите на dreamer@aport.ru
next reply other threads:[~2003-04-21 10:26 UTC|newest] Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top 2003-04-21 10:26 Петров А.В. [this message] 2003-04-21 11:34 ` Antonio 2003-04-21 14:03 ` Петров А.В. 2003-04-21 14:20 ` [Comm] " Sergey Vlasov 2003-04-22 5:52 ` [Comm] " Борис Ревякин 2003-04-22 6:40 ` Antonio 2003-04-21 12:47 ` [Comm] " Sergey Vlasov
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=200304211426.43089.dreamer@aport.ru \ --to=dreamer@aport.ru \ --cc=community@altlinux.ru \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: link
ALT Linux Community general discussions This inbox may be cloned and mirrored by anyone: git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git # If you have public-inbox 1.1+ installed, you may # initialize and index your mirror using the following commands: public-inbox-init -V2 community community/ http://lore.altlinux.org/community \ mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com public-inbox-index community Example config snippet for mirrors. Newsgroup available over NNTP: nntp://lore.altlinux.org/org.altlinux.lists.community AGPL code for this site: git clone https://public-inbox.org/public-inbox.git