On Sun, Mar 16, 2003 at 09:28:47PM +0300, Anton Farygin wrote:
> Artem K. Jouravsky пишет:
> 
> >Доброго времени суток!
> >Люди, почему может быть не виден SCSI диск?
> >в dmesg нашёл следующее:
> > 
> >
> В ядре 2.4.20-alt5 должен заработать.
[root@oracle root]# uname -r
2.4.20-alt5-smp
Та же песня.

sym.0.10.0: setting PCI_COMMAND_PARITY...
sym.0.10.0: setting PCI_COMMAND_INVALIDATE.
sym.0.10.1: setting PCI_COMMAND_PARITY...
sym.0.10.1: setting PCI_COMMAND_INVALIDATE.
sym0: <1010-33> rev 0x1 on pci bus 0 device 10 function 0 irq 11
sym0: using 64 bit DMA addressing
sym0: Symbios NVRAM, ID 7, Fast-80, LVD, parity checking
sym0: open drain IRQ line driver, using on-chip SRAM
sym0: using LOAD/STORE-based firmware.
sym0: handling phase mismatch from SCRIPTS.
sym0: SCAN AT BOOT disabled for targets 1 2 3 4 5 6 8 10 11 12 13 14 15.
sym0: SCSI BUS has been reset.
sym1: <1010-33> rev 0x1 on pci bus 0 device 10 function 1 irq 11
sym1: using 64 bit DMA addressing
sym1: Symbios NVRAM, ID 7, Fast-80, SE, parity checking
sym1: open drain IRQ line driver, using on-chip SRAM
sym1: using LOAD/STORE-based firmware.
sym1: handling phase mismatch from SCRIPTS.
sym1: SCAN AT BOOT disabled for targets 0 1 2 3 4 5 6 8 9 10 11 12 13 14 15.
sym1: SCSI BUS has been reset.
scsi0 : sym-2.1.17a
scsi1 : sym-2.1.17a
blk: queue cfbabe18, I/O limit 1048575Mb (mask 0xffffffffff)
sym0: SCSI parity error detected: SCR1=1 DBC=1100005c SBCL=ae
sym0: SCSI parity error detected: SCR1=1 DBC=b000000 SBCL=2b
sym0: SCSI parity error detected: SCR1=1 DBC=f000000 SBCL=6f
sym0: SCSI BUS reset detected.
sym0: SCSI BUS has been reset.



-- 
Best wishes,                 | ICQ 103399444
	Artem K. Jouravsky,  | JID ujo@jabber.ru
iFirst Ltd, System Administrator.
-----------------------
Какой русский не любит мокрой ..езды?!!