ALT Linux Community general discussions
 help / color / mirror / Atom feed
From: "Ярослав Кохан" <campana@ukr.net>
To: community@altlinux.ru
Subject: Re[2]: [Comm] звук на EpoxEP-RDA3+
Date: Wed, 29 Oct 2003 00:06:23 +0200
Message-ID: <1755345406.20031029000623@ukr.net> (raw)
In-Reply-To: <20031024101443.GC6237@master.mivlgu.local>

Пробовал я выполнять все советы по звуку, тут даваемые, но что-то
ничего не получается.

Вот modules.conf:
above snd-pcm-oss snd-mixer-oss
alias usb-interface usb-ohci
above snd-intel8x0 snd-pcm-oss
pre-install pcmcia_core CARDMGR_OPTS=-f /etc/rc.d/init.d/pcmcia start
alias sound-slot-0 snd-intel8x0
alias eth0 nvnet
alias eth1 8139too
alias usb-interface1 ehci-hcd
alias ieee1394-controller ohci1394

посмотрел на
# lspci
там есть строчка
00:06.0 Multimedia audio controller: nVidia Corporation nForce2 AC97 Audio Controler (MCP) (rev a1)

Про альзу и oss:

$ rpm -qa |grep alsa
kernel-modules-alsa-std-up-0.9.7-alt1.4
alsa-utils-0.9.7-alt1
kernel-doc-alsa-0.9.7-0.9.7-alt1c
xmms-alsa-0.9.12-alt1
libalsa-0.9.7-alt1

$ rpm -qa |grep oss
kernel-modules-slicoss-std-up-1.2.0-alt3.4

$ rpm -ql libaudio
/usr/X11R6/lib/X11/AuErrorDB
/usr/X11R6/lib/libaudio.so.2
/usr/X11R6/lib/libaudio.so.2.3

Здесь все есть?
--------------
Кстати, bash кочевряжится (или кто там уже от его
имени):

# service kudzu status
bash: service: command not found
# rpm -q service
service-0.5.2-alt1

Тогда чего он не находит? Аналогично:

# sndconfig --quiet
bash: sndconfig: command not found
# rpm -q sndconfig
sndconfig-0.69-alt1

А за одно и

# depmod -a
bash: depmod: command not found
[root@localhost Audio]# rpm -q depmod
предупреждение: пакет depmod не установлен
[root@localhost Audio]# apt-cache search depmod
[root@localhost Audio]#

то есть, тишина в ответ.
------------------------
Далее, смотрим
# amixer contents
там все значения 0 или off, кроме следующих:
numid=1,iface=MIXER,name='Master Playback Switch'
  ; type=BOOLEAN,access=rw---,values=1
  : values=on
numid=2,iface=MIXER,name='Master Playback Volume'
  ; type=INTEGER,access=rw---,values=2,min=0,max=31,step=0
  : values=21,21
numid=4,iface=MIXER,name='Center Playback Volume'
  ; type=INTEGER,access=rw---,values=1,min=0,max=31,step=0
  : values=31
numid=28,iface=MIXER,name='Capture Switch'
  ; type=BOOLEAN,access=rw---,values=1
  : values=on
 numid=32,iface=MIXER,name='IEC958 Playback Con Mask'
  ; type=IEC958,access=r----,values=1
  : values=?
numid=33,iface=MIXER,name='IEC958 Playback Pro Mask'
  ; type=IEC958,access=r----,values=1
  : values=?
numid=34,iface=MIXER,name='IEC958 Playback Default'
  ; type=IEC958,access=rw---,values=1
  : values=?

Заглядываем в
/proc/asound/oss:

Sound Driver:3.8.1a-980706 (ALSA v0.9.7 emulation code)
Kernel: Linux localhost.localdomain 2.4.22-std-up-alt4 #1 Wed Sep 24 17:35:25 MSD 2003 i686
Config options: 0

Installed drivers:
Type 10: ALSA emulation

Card config:
NVidia nForce2 at 0xef001000, irq 21

Audio devices:
0: NVidia nForce2 (DUPLEX)

Synth devices: NOT ENABLED IN CONFIG

Midi devices: NOT ENABLED IN CONFIG

Timers:
7: system timer

Mixers:
0: C-Media Electronics CMI9739

Заглядываем в
/proc/asound/nForce2:

VOLUME "Master" 0
BASS "" 0
TREBLE "" 0
SYNTH "" 0
PCM "PCM" 0
SPEAKER "PC Speaker" 0
LINE "Line" 0
MIC "Mic" 0
CD "CD" 0
IMIX "" 0
ALTPCM "" 0
RECLEV "" 0
IGAIN "Capture" 0
OGAIN "" 0
LINE1 "Aux" 0
LINE2 "" 0
LINE3 "" 0
DIGITAL1 "" 0
DIGITAL2 "" 0
DIGITAL3 "" 0
PHONEIN "Phone" 0
PHONEOUT "" 0
VIDEO "Video" 0
RADIO "" 0
MONITOR "" 0

Это нормально, что все на нуле?

Заглядываем в
/proc/asound/ac97#0:

0-0/0: C-Media Electronics CMI9739

Capabilities     :
DAC resolution   : 16-bit
ADC resolution   : 16-bit
3D enhancement   : No 3D Stereo Enhancement

Current setup
Mic gain         : +20dB [+20dB]
POP path         : pre 3D
Sim. stereo      : off
3D enhancement   : off
Loudness         : off
Mono output      : MIX
Mic select       : Mic1
ADC/DAC loopback : off
Extended ID      : codec=0 rev=1 LDAC SDAC CDAC DSA=0 SPDIF DRA
Extended status  : SPCV LDAC SDAC CDAC SPDIF=6/9 SPDIF
SPDIF Control    : Consumer PCM Copyright Category=0x22 Generation=1 Rate=48kHz

Тут вообще ничего не понимаю.
-----------------------------
Пробовал запускать Альзу и Ноатун. Дергал аумикс и кмикс (так как в
KDE живу). Все без толку. Иногда при включении/выключении ползунка CD
в кмиксе как будто появляется в наушниках шум на долю секунды и
исчезает. Дальше снова тишина.

-- 
Best regards,
 Ярослав                            mailto:campana@ukr.net




  parent reply	other threads:[~2003-10-28 22:06 UTC|newest]

Thread overview: 17+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2003-10-21  1:29 [Comm] NVidia Ярослав Кохан
2003-10-21  4:14 ` Ерлан Ибраев
2003-10-21  4:18   ` Re[2]: " Evgeny Yugov
2003-10-21  5:34     ` Ерлан Ибраев
2003-10-21  6:35 ` [Comm] Re: звук на Epox EP-RDA3+ Vitaly Lipatov
2003-10-21 18:54   ` Alexandr
2003-10-22  4:22     ` Vitaly Lipatov
2003-10-22 20:39       ` [Comm] Re: звук на EpoxEP-RDA3+ Alexandr
2003-10-23  9:20         ` Sergey Vlasov
2003-10-23 16:45           ` [Comm] СпаRe: " Alexandr
2003-10-24 10:14             ` Sergey Vlasov
2003-10-24 19:01               ` [Comm] " Alexandr
2003-10-25 14:20                 ` Sergey Vlasov
2003-10-26 20:37                   ` Alexandr
2003-10-28 22:06               ` Ярослав Кохан [this message]
2003-10-22  9:14     ` [Comm] Re: звук на Epox EP-RDA3+ Sergey Vlasov
2003-10-21 13:45 ` [Comm] NVidia Canis Cerberus

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1755345406.20031029000623@ukr.net \
    --to=campana@ukr.net \
    --cc=community@altlinux.ru \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

ALT Linux Community general discussions

This inbox may be cloned and mirrored by anyone:

	git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 community community/ http://lore.altlinux.org/community \
		mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com
	public-inbox-index community

Example config snippet for mirrors.
Newsgroup available over NNTP:
	nntp://lore.altlinux.org/org.altlinux.lists.community


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git