* [mdk-re] Re: [mdk-re] Установка и удаление программ (пакетов)
2001-05-19 5:35 ` [mdk-re] Установка и удаление программ (пакетов) Anton Denisov
@ 2001-05-19 5:58 ` Aleksey Novodvorsky
2001-05-19 7:50 ` [mdk-re] Установка иудаление программ(пакетов) Dmitry Samoyloff
2001-05-19 11:05 ` [mdk-re] Re: [mdk-re] Установка и удаление программ (пакетов) Yura Zotov
2 siblings, 0 replies; 4+ messages in thread
From: Aleksey Novodvorsky @ 2001-05-19 5:58 UTC (permalink / raw)
To: mandrake-russian
Anton Denisov wrote:
> Здравствуйте, подписчики Mandrake-russian mailing.
> Вот поставил пару недель назад Linux Mandrake 7.0 RE (хотя тут уже,
> наверное, у всех Spring стоит) на свой компьютер (Celeron 700/64 RAM/256
> SWAP/ASUS CUSL2 с интегрированным видео на i815/20 Gb HDD Fujitsu), как
> единственную ОС. Установка прошла гладко, за что и спасибо разработчикам !
Спасибо!
>
> Только по умолчанию Postfix не заработал, что то было с путем к aliases или
> aliases.db, подправил - всё заработало. Вник немного в дистрибутив и Linux
> вообще и решил доставить пару пакетов: скачал из Интернета пакет в виде
> i586.rpm и попытался его поставить (rpm -ivh <имя пакета>), на что rpm выдал
> мне ошибку про то что данная версия rpm поддерживает пакеты только версий
> <=3. Я правильно понял, что моя версия программы rpm не поддерживает
> установку данного пакета, так как он собран для rpm версии 4?
Да, увы.
> Что делают в
> таких случаях ?
Обновляются. К сожалению, сейчас пакеты собираются под новой версией glibc, а
ее обновить уже сложнее.
> Также заметил что mc на таких пакетах, когда на нем нажмёшь
> Enter, сильно "глючит" (экран становится красным и разваливается на куски ).
> Решил также обновить Blackbox 0.51 (из дистрибутива) на Blackbox 0.61, мне
> его знакомый дал в виде tar.gz , я удалил старый Blackbox (rpm -e blackbox)
> и поставил новый (./configure;make;make install), предварительно его
> распаковав, так вот теперь мне интересно: rpm -qa | grep Blackbox
> естественно ничего не выдаёт (ведь я поставил его не из rpm пакета), так как
> его удалить если захочу или просмотреть список файлов в нем и куда он их
> раскидал ? Неужели всё смотреть в makefile, а файлы удалять по одному ?
Да. Правда, если в тарболе (tar.gz) есть файл типа blackbox.spec или
blackbox.spec.in, то можно посомтреть в нем список файлов (секция %files) и
удалять по списку. Именно для решения этой проблемы и созданы менеджеры
пакетов.
Rgrds, AEN
^ permalink raw reply [flat|nested] 4+ messages in thread
* Re: [mdk-re] Установка иудаление программ(пакетов)
2001-05-19 5:35 ` [mdk-re] Установка и удаление программ (пакетов) Anton Denisov
2001-05-19 5:58 ` [mdk-re] " Aleksey Novodvorsky
@ 2001-05-19 7:50 ` Dmitry Samoyloff
2001-05-19 11:05 ` [mdk-re] Re: [mdk-re] Установка и удаление программ (пакетов) Yura Zotov
2 siblings, 0 replies; 4+ messages in thread
From: Dmitry Samoyloff @ 2001-05-19 7:50 UTC (permalink / raw)
To: mandrake-russian
19 Май 2001 06:15, Anton Denisov wrote:
> ). Решил также обновить Blackbox 0.51 (из дистрибутива) на Blackbox 0.61,
> мне его знакомый дал в виде tar.gz , я удалил старый Blackbox (rpm -e
> blackbox) и поставил новый (./configure;make;make install), предварительно
> его распаковав, так вот теперь мне интересно: rpm -qa | grep Blackbox
> естественно ничего не выдаёт (ведь я поставил его не из rpm пакета), так
> как его удалить если захочу или просмотреть список файлов в нем и куда он
> их раскидал ? Неужели всё смотреть в makefile, а файлы удалять по одному ?
Здравствуйте!
Попробуйте сделать `make uninstall` под root.
С уважением, Дмитрий Самойлов
http://linuxgames.hut.ru (Russian)
http://www.geocities.com/sleepws/
^ permalink raw reply [flat|nested] 4+ messages in thread
* [mdk-re] Re: [mdk-re] Установка и удаление программ (пакетов)
2001-05-19 5:35 ` [mdk-re] Установка и удаление программ (пакетов) Anton Denisov
2001-05-19 5:58 ` [mdk-re] " Aleksey Novodvorsky
2001-05-19 7:50 ` [mdk-re] Установка иудаление программ(пакетов) Dmitry Samoyloff
@ 2001-05-19 11:05 ` Yura Zotov
2 siblings, 0 replies; 4+ messages in thread
From: Yura Zotov @ 2001-05-19 11:05 UTC (permalink / raw)
To: mandrake-russian
On Sat, May 19, 2001 at 02:15:30PM +1200, Anton Denisov wrote:
> Здравствуйте, подписчики Mandrake-russian mailing.
<skip>
> Вник немного в дистрибутив и Linux
> вообще и решил доставить пару пакетов: скачал из Интернета пакет в виде
> i586.rpm и попытался его поставить (rpm -ivh <имя пакета>), на что rpm выдал
> мне ошибку про то что данная версия rpm поддерживает пакеты только версий
> <=3. Я правильно понял, что моя версия программы rpm не поддерживает
> установку данного пакета, так как он собран для rpm версии 4? Что делают в
> таких случаях ?
Я бы обновил дистрибутив. RPM - основная программа, которая держит всю
систему в целости, менять ее на "чужую" нельзя. Можно еще порыться на FTP
и скачать ВСЕ необходимые обновления для 7.0RE, чтобы обновить RPM, но это
ОЧЕНЬ много, даже я не смог до конца все обновить.
Еще можно пытаться вытянуть src.rpm, взять из него исходники и *.spec
исправить последний и собрать новый пакет для себя.
Однако трудно. И так для всех новых пакетов.
> Также заметил что mc на таких пакетах, когда на нем нажмёшь
> Enter, сильно "глючит" (экран становится красным и разваливается на куски ).
Естественно.
> Решил также обновить Blackbox 0.51 (из дистрибутива) на Blackbox 0.61, мне
> его знакомый дал в виде tar.gz , я удалил старый Blackbox (rpm -e blackbox)
> и поставил новый (./configure;make;make install), предварительно его
> распаковав, так вот теперь мне интересно: rpm -qa | grep Blackbox
> естественно ничего не выдаёт (ведь я поставил его не из rpm пакета), так как
> его удалить если захочу или просмотреть список файлов в нем и куда он их
> раскидал ? Неужели всё смотреть в makefile, а файлы удалять по одному ?
> Извиняюсь что длинное письмо получилось.
>
make uninstall должно помочь с удалением.
--
Юрий А. Зотов
^ permalink raw reply [flat|nested] 4+ messages in thread