From: Boris Muradov <boris.muradov@mail.ru> To: community@lists.altlinux.org Subject: [Comm] madwifi+wpa_supplicant Date: Sun, 04 Nov 2007 20:47:00 +0300 Message-ID: <E1IojYq-000ED9-00.boris-muradov-mail-ru@f133.mail.ru> (raw) Здравствуйте, Сompact 3.0. 802.11 chipset Atheros. пробую подключиться к wifi точке доступа через WPA-PKS (через WEP все ок). для поддержки WPA на чипсете Atheros обновлены: kernel-modules-madwifi-std-smp-0.9.14.9 wpa_supplicant-0.5.8-alt1 ядро чипсет вроде распознало: ath_hal: 0.9.14.9 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413) ath_rate_onoe: 1.0 ath_pci: 0.9.4.12 (EXPERIMENTAL) ath0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps ath0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps ath0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps ath0: mac 5.9 phy 4.3 radio 3.6 ath0: 802.11 address: 00:0e:9b:c6:90:8f ath0: Use hw queue 0 for WME_AC_BE traffic ath0: Use hw queue 1 for WME_AC_BK traffic ath0: Use hw queue 2 for WME_AC_VI traffic ath0: Use hw queue 3 for WME_AC_VO traffic ath0: Atheros 5212: mem=0xd0200000, irq=21 точка доступа видна (iwlist ath0 scan): Cell 05 - Address: 00:60:B3:D8:17:6C ESSID:"ADSL_Wireless" Mode:Master Frequency:2.437 GHz (Channel 6) Quality=30/94 Signal level=-65 dBm Noise level=-95 dBm Encryption key:on Bit Rate:1 Mb/s Bit Rate:2 Mb/s Bit Rate:5 Mb/s Bit Rate:6 Mb/s Bit Rate:9 Mb/s Bit Rate:11 Mb/s Bit Rate:12 Mb/s Bit Rate:18 Mb/s Bit Rate:22 Mb/s Bit Rate:24 Mb/s Bit Rate:36 Mb/s Bit Rate:48 Mb/s Bit Rate:54 Mb/s Extra:bcn_int=200 Extra:wpa_ie=dd160050f20101000050f20201000050f20201000050f202 /etc/wpa_supplicant.conf - проще некуда network={ ssid="ADSL_Wireless" key_mgmt=WPA-PSK proto=WPA pairwise=TKIP group=TKIP psk=7a31cd1c5479c395a83f2916711735e2fda0773dd09ced939e7c0a8f07ec2229 } на дальше ничего не получилось, помогите, pls, разобраться, прошу извинить за длинный листинг. wpa_supplicant -iath0 -Dmadwifi -c /etc/wpa_supplicant.conf ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported ioctl[SIOCGIWSCAN]: Resource temporarily unavailable ioctl[IEEE80211_IOCTL_SETMLME]: Operation not supported ioctl[IEEE80211_IOCTL_SETMLME]: Operation not supported ioctl[IEEE80211_IOCTL_SETMLME]: Operation not supported Initializing interface 'ath0' conf '/etc/wpa_supplicant.conf' driver 'madwifi' ctrl_interface 'N/A' bridge 'N/A' Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf' Reading configuration file '/etc/wpa_supplicant.conf' Line: 1 - start of a new network block ssid - hexdump_ascii(len=13): 41 44 53 4c 5f 57 69 72 65 6c 65 73 73 ADSL_Wireless key_mgmt: 0x2 proto: 0x1 pairwise: 0x8 group: 0x8 PSK - hexdump(len=32): 7a 31 cd 1c 54 79 c3 95 a8 3f 29 16 71 17 35 e2 fd a0 77 3d d0 9c ed 93 9e 7c 0a 8f 07 ec 22 29 Priority group 0 id=0 ssid='ADSL_Wireless' Initializing interface (2) 'ath0' EAPOL: SUPP_PAE entering state DISCONNECTED EAPOL: KEY_RX entering state NO_KEY_RECEIVE EAPOL: SUPP_BE entering state INITIALIZE EAP: EAP entering state DISABLED EAPOL: External notification - portEnabled=0 EAPOL: External notification - portValid=0 SIOCGIWRANGE: too old (short) data - assuming WPA is not supported WEXT: Operstate: linkmode=1, operstate=5 Own MAC address: 00:0e:9b:c6:90:8f wpa_driver_madwifi_del_key: keyidx=0 wpa_driver_madwifi_del_key: keyidx=1 wpa_driver_madwifi_del_key: keyidx=2 wpa_driver_madwifi_del_key: keyidx=3 wpa_driver_madwifi_set_countermeasures: enabled=0 wpa_driver_madwifi_set_drop_unencrypted: enabled=1 Setting scan request: 0 sec 100000 usec Added interface ath0 RTM_NEWLINK: operstate=0 ifi_flags=0x1043 ([UP][RUNNING]) Wireless event: cmd=0x8b15 len=20 Wireless event: new AP: 00:00:00:00:00:00 Added BSSID 00:00:00:00:00:00 into blacklist CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys wpa_driver_madwifi_del_key: keyidx=0 wpa_driver_madwifi_del_key: keyidx=1 wpa_driver_madwifi_del_key: keyidx=2 wpa_driver_madwifi_del_key: keyidx=3 wpa_driver_madwifi_del_key: keyidx=0 State: DISCONNECTED -> DISCONNECTED wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT) WEXT: Operstate: linkmode=-1, operstate=5 EAPOL: External notification - portEnabled=0 EAPOL: External notification - portValid=0 RTM_NEWLINK: operstate=0 ifi_flags=0x1043 ([UP][RUNNING]) Wireless event: cmd=0x8b06 len=8 RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP]) RTM_NEWLINK, IFLA_IFNAME: Interface 'ath0' added State: DISCONNECTED -> SCANNING Starting AP scan (broadcast SSID) Trying to get current scan results first without requesting a new scan to speed up initial association Scan results: -1 Failed to get scan results Failed to get scan results - try scanning again Setting scan request: 0 sec 0 usec Starting AP scan (broadcast SSID) RTM_NEWLINK: operstate=0 ifi_flags=0x1043 ([UP][RUNNING]) Wireless event: cmd=0x8b1a len=12 RTM_NEWLINK: operstate=0 ifi_flags=0x1043 ([UP][RUNNING]) Wireless event: cmd=0x8b19 len=12 Received 1340 bytes of scan results (7 BSSes) Scan results: 7 Selecting BSS from priority group 0 Try to find WPA-enabled AP 0: 00:60:b3:d8:17:6c ssid='ADSL_Wireless' wpa_ie_len=24 rsn_ie_len=0 caps=0x11 selected based on WPA IE selected WPA AP 00:60:b3:d8:17:6c ssid='ADSL_Wireless' Try to find non-WPA AP Trying to associate with 00:60:b3:d8:17:6c (SSID='ADSL_Wireless' freq=2437 MHz) Cancelling scan request WPA: clearing own WPA/RSN IE Automatic auth_alg selection: 0x1 WPA: using IEEE 802.11i/D3.0 WPA: Selected cipher suites: group 8 pairwise 8 key_mgmt 2 proto 1 WPA: set AP WPA IE - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02 WPA: clearing AP RSN IE WPA: using GTK TKIP WPA: using PTK TKIP WPA: using KEY_MGMT WPA-PSK WPA: Set own WPA IE default - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02 No keys have been configured - skip key clearing wpa_driver_madwifi_set_drop_unencrypted: enabled=1 State: SCANNING -> ASSOCIATING wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT) WEXT: Operstate: linkmode=-1, operstate=5 wpa_driver_madwifi_associate wpa_driver_madwifi_associate: SETMLME[ASSOC] failed Association request to the driver failed Setting authentication timeout: 5 sec 0 usec EAPOL: External notification - EAP success=0 EAPOL: External notification - EAP fail=0 EAPOL: External notification - portControl=Auto RTM_NEWLINK: operstate=0 ifi_flags=0x1043 ([UP][RUNNING]) Wireless event: cmd=0x8b1a len=26 Authentication with 00:00:00:00:00:00 timed out. Added BSSID 00:60:b3:d8:17:6c into blacklist No keys have been configured - skip key clearing State: ASSOCIATING -> DISCONNECTED
next reply other threads:[~2007-11-04 17:47 UTC|newest] Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top 2007-11-04 17:47 Boris Muradov [this message] 2007-11-04 19:15 ` А.Китайкин 2007-11-04 19:15 ` Peter V. Saveliev
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=E1IojYq-000ED9-00.boris-muradov-mail-ru@f133.mail.ru \ --to=boris.muradov@mail.ru \ --cc=community@lists.altlinux.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: link
ALT Linux Community general discussions This inbox may be cloned and mirrored by anyone: git clone --mirror http://lore.altlinux.org/community/0 community/git/0.git # If you have public-inbox 1.1+ installed, you may # initialize and index your mirror using the following commands: public-inbox-init -V2 community community/ http://lore.altlinux.org/community \ mandrake-russian@linuxteam.iplabs.ru community@lists.altlinux.org community@lists.altlinux.ru community@lists.altlinux.com public-inbox-index community Example config snippet for mirrors. Newsgroup available over NNTP: nntp://lore.altlinux.org/org.altlinux.lists.community AGPL code for this site: git clone https://public-inbox.org/public-inbox.git